[QuadList] Bill's AVR-2 bridge switcher NOW with low band bars

[C. Park Seward]

Hi Don,

Right.  No separate Vel Comp on the Ampex/Merlin machine. And no  
Colortec monitor either. They have a special Amtec setting that shows  
the guide error. And the chroma setting.

Ran a low band color tape today that didn't look too bad. A little 60  
hum recorded in the picture.


Best,
Park

C. Park Seward
Visit us: http://www.videopark.com



On Sep 15, 2009, at 4:26 PM, Don Norwood wrote:

> Park:
>
> On a "non-Merlin" machine, Velocity error is the signal to monitor  
> when setting guide height (assuming it has Velcomp installed!).   
> Does the Merlin machine have an equivalent monitor signal for  
> velocity?
>
> Don
> ----- Original Message -----
> From: C. Park Seward
>
> To that point, on a 1200B, I like to set a scope to "AMTEC error"  
> which helps set the tip penetration and guide height. The servo  
> works well but I like to monitor it. A separate waveform and  
> vectorscope is attached to the video out.
>
> Best,
> Park
> _______________________________________________
> Please trim posts to relevant info when replying!
> Send QuadList list posts to QuadList at quadvideotapegroup.com
> Your subscribe, unsubscribe and digest options are here:
> http://mail.quadvideotapegroup.com/mailman/listinfo/quadlist_quadvideotapegroup.com

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://quadvideotapegroup.com/pipermail/quadlist_quadvideotapegroup.com/attachments/20090915/897fd510/attachment-0005.html>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: low band bars.jpg
Type: image/jpg
Size: 58178 bytes
Desc: not available
URL: <http://quadvideotapegroup.com/pipermail/quadlist_quadvideotapegroup.com/attachments/20090915/897fd510/attachment-0003.jpg>