[QuadList] TCR-100 (was 1" Machine glue)

[sgw1009]

Hi Don,

 

RCA had a rather ingenious way of threading the tape into the guide on a
TCR100.  As the tape was ready to go into the guide, they spun the head very
briefly which aided in properly seating the tape. This was quickly followed
by a short burst of the electronic brake, which provided backspin on the
head just enough to make it stop.  I had a machine that started
mis-threading on a regular basis.  Turned out the electronic brake was being
activated too long and kicking the tape back out of the guide.  Had to
videotape the process then analyze it in slow motion to figure that one out.

 

Steve Walton

 

  _____  

From: quadlist-bounces at quadvideotapegroup.com
[mailto:quadlist-bounces at quadvideotapegroup.com] On Behalf Of Don Norwood
Sent: Wednesday, February 03, 2010 10:17 AM
To: Quad List
Subject: Re: [QuadList] TCR-100 (was 1" Machine glue)

 

----- Original Message ----- 

From: "Dennis Degan" < <mailto:DennyD1 at verizon.net> DennyD1 at verizon.net>


On Feb 2, 2010, at 5:44 PM, Don Norwood wrote:

 > I never had more than a casual look at the TCR-100, and didn't 
realize that it used the same head as the other machines. Threading 
must have been quite a trick. How did they do that? 

I offer:

Unlike the Ampex machine's cartridges, RCA's carts could open in a way 
that exposed the tape at 3 sides.  Aluminum doors that wrapped around 
the cartridge would open, rotating on their spring-loaded hinges 90 
degrees.  This allowed a pair of pins to reach into the cart and pull 
the tape out.  The pins were each mounted on a machined polished track 
driven by a bicycle chain.  Each travelled a distance of about 2 feet 
diagonally in order to span the vertically-mounted width of the 
transport.  Though nowhere near as fast as the Ampex machine, the 
movement of those pins was fast enough to be dangerous if your hand was 
in the wrong place at the wrong time.
The entire assembly would then move horizontally to thread the tape 
across the erase, audio, quad video heads, capstan and guides, aided by 
guide blocks, which was followed by a slight retraction of the guide 
pins to avoid tape motion interference.  The action was reversed to 
return the tape loop back into the cartridge.

Dennis Degan, Video Editor-Consultant-Knowledge Bank
  NBC Today Show, New York

Hi Dennis:

 

The part I was unclear on was specifically the tape threading into the head
assembly.  Ampex's retractable guide made it easy, but I had not thought
about RCA using a standard head.  Were the guide blocks you mentioned
attached to the head or to the TCR frame?  The Youtube video isn't quite
good enough to see the detail.  I guess I need to go to Boston and see
Paul's machine in action!

 

Don

 

Don Norwood
www.digitrakcom.com

 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://quadvideotapegroup.com/pipermail/quadlist_quadvideotapegroup.com/attachments/20100203/1a51a875/attachment-0005.html>