[QuadList] What is it????

[Chill315 at aol.com]

Yes I did notice that the module was missing the pull handle.  The  card 
does have the 28 pin connector that the AVR-1 used.  The 63.5 micro  second 
delay line is used in the drop out compensator of the AVR-1.
 
The front connectors are what throw me for a loop.  So I am at a  loss.  
 
It is for a quad you say so that does not leave much left.
 
Chris Hill
 
 
In a message dated 5/13/2011 10:09:05 P.M. Eastern Daylight Time,  
dwnorwood at embarqmail.com writes:

Hi Chris:
 
Almost a winning answer, maybe the best so far.....but  you'll notice that 
this module design (mechanical, not electrical) is slightly  different from 
the AVR-1.
 
Don Norwood
Digitrak Communications, Inc.
_www.digitrakcom.com_ (http://www.digitrakcom.com/)   

----- Original Message ----- 
From:  _Chill315 at aol.com_ (mailto:Chill315 at aol.com)  
To: _quadlist at quadvideotapegroup.com_ 
(mailto:quadlist at quadvideotapegroup.com)   
Sent: Friday, May 13, 2011 9:54  PM
Subject: Re: [QuadList] What is  it????


This is the one line delay module that was used in the AVR-1 /  ACR-25.  
 
Chris Hill
WA8IGN
 
 



_______________________________________________
Please  trim posts to relevant info when replying!
Send QuadList list posts to  QuadList at quadvideotapegroup.com
Your subscribe, unsubscribe and digest  options are  here:
http://mail.quadvideotapegroup.com/mailman/listinfo/quadlist_quadvideotapegr
oup.com

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://quadvideotapegroup.com/pipermail/quadlist_quadvideotapegroup.com/attachments/20110513/38ecab3f/attachment-0005.html>