[QuadList] TRT-1 rack 4

[Dave Sieg]

There was also a big honkin 24V supply in either rack 4 or 5.
This machine also had a small gast compressor shock-mounted in a
"soundproof" metal
rackmount box with a small air tank under it.  This supplied 40psi for the
headwheel.
Rack 5 had the rack frame for the solid-state headwheel servo.
This machine had the WP-16 supplies, 400V @ 1.5A on a delay timer as I
recall.

On Thu, Dec 27, 2012 at 10:53 AM, <chill315 at aol.com> wrote:

>
> Because of the picture of the RCA tag for a TRT rack 4, I asked the
> question about the layout.
>
> There were several versions so here is the best that I can do.
>
> If it was equipped with the WP-16 solid state supply, the layout was
>
> Two motor drive amps at the top for the capstan.
>          There were about three different versions of these.
>
> The capstan servo chassis.
>
> The 150 volt power supply.
>
> The reference generator.
>
> And lastly two WP-16 power supplies.
>
> If the machine had WP-15 power supplies, it required three.  Also the
> regulators were in different rack.  Including one in this rack.
>
> Chris Hill
> ______________________________________________
> Please trim posts to relevant info when replying.
>
> Change subject to reflect thread direction. Thanks.
> _______________________________________________
>
> Send QuadList list posts to QuadList at quadvideotapegroup.com
> Your subscribe, unsubscribe and digest options are here:
>
> http://mail.quadvideotapegroup.com/mailman/listinfo/quadlist_quadvideotapegroup.com
>



-- 
Dave Sieg
www.linkedin.com/in/davesieg
www.davesieg.com
www.scanimate. <http://www.scanimate.net>com
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://quadvideotapegroup.com/pipermail/quadlist_quadvideotapegroup.com/attachments/20121227/16b76f2d/attachment-0005.html>