[QuadList] Amtec no output

[L.E. Odham]

Hi David, 





Go to Amtec board #4, put a meter on the two test points: check for +12vdc and -12vdc. 



If its there, board 11 or 12 or the delay line  may be at fault. 11 gets the line video in before the delay line, 12 puts the video out after the delay line. 



All the other Amtec boards dont come into use until tape is being played back and the switch is in one of the correction modes(would be ext. ref. for intersync) 


OK, hope this helps some, 

larry 



LE Odham 

Engr/Tech 

TAMIS Archive 


----- Original Message -----


From: "David Dean" <dixie at westpoint.tv> 
To: "Quad List" <quadlist at quadvideotapegroup.com> 
Sent: Wednesday, February 15, 2012 1:50:41 PM 
Subject: [QuadList] Amtec no output 


Hi List 
  
My Amtec has died giving no output, I am very lost as I have no circuits for the unit,  I do know video is getting to the delay, and getting through it but that is about all. Any good test points? a block diagram, or circuits would be a help. 
  
Thanks 
  
David Dean 
Westpoint Television 
Archiving Services 
2" Quad , 1" B, 1"C, D1, D2, D3, D5, HDCam and HDV 
.5", EIAJ, In Various Standards where supported 
Alchemist Ph.C conversions with Clean Cut 
Snell and Wilcox Ukon for HD frame rate conversions and Up and Down conversions 
Digital Vision DVNR with scratch  and dropout concealment 
Tel 020 8742 3400 
Please trim posts to relevant info when replying. 

Change subject to reflect thread direction. Thanks. 
_______________________________________________ 

Send QuadList list posts to QuadList at quadvideotapegroup.com 
Your subscribe, unsubscribe and digest options are here: 
http://mail.quadvideotapegroup.com/mailman/listinfo/quadlist_quadvideotapegroup.com
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://quadvideotapegroup.com/pipermail/quadlist_quadvideotapegroup.com/attachments/20120215/6c5a75ef/attachment-0004.html>