[QuadList] The Digitrak Tape area

[chill315 at aol.com]

Thanks for the good information.  

I grew to hate the moveable guides.  But if you kept after it, not that bad.

You have pulled some stuff out of the lost areas of the brain.  Maybe it was a form of suppression or CRS.

Now I always thought that if Ampex could have the electronics and IVC the deck, then it might have worked better.

LOL

Chris Hill

On Apr 19, 2013, at 9:21 AM, "Don Norwood" <dwnorwood at embarqmail.com> wrote:

> 
> Hi Chris:
>  
> On th 7800, the proc amp was on the right end of the main front card cage.  The two rear card areas accessible from the top of the machine were for heterodyne color and dropout comp.  The 7800 was before any TBC was available.
>  
> The VPR-7900 was the first machine to have a companion TBC.  While the machine looks much like the earlier 7800, there are some major differences.  Probably most significant would be the addition of a 3rd carrier mode which is the same as Hi-Band quad and 1" Type-C, and the servo  system which was the first 1" to have H-lock capability, allowing it to work with the small correction window that was then available with analog TBC's.  There are many other differences, but along with direct color recovery (no heterodyne), the VPR-7900/TBC-790 made 1" truly broadcast capable for the first time.
>  
> The biggest problem with the 7900 (and all of its Type-A predecessors) was the movable guides.  That of course was fixed with the VPR-1.  However, as visitors here can attest, the 7900 when properly set up looks just as good as Type-C.  To be fair, we use a TBC-7 instead of the original TBC-790, so correction range is much greater than the original, but the 7900 was the beginning of proving that 1" could be a viable alternative to quad.
>  
> Don Norwood
> Digitrak Communications, Inc.
> www.digitrakcom.com
> ----- Original Message -----
> From: chill315 at aol.com
> To: Quad List
> Sent: Friday, April 19, 2013 12:41 AM
> Subject: Re: [QuadList] The Digitrak Tape area
> 
> 
> I had a 7800 and it was not that great a machine.  The proc amp may have been under the right rear cover.  Then the left rear may have been for a simple TBC.  can anyone confirm that?
> 
> Chris Hill
> 
> On Apr 19, 2013, at 12:11 AM, "Don Norwood" <dwnorwood at embarqmail.com> wrote:
> 
>> I knew David would know!  Here's a pic of the other VPR-7900 we have before a capstan replacement.  There's even sort of a quad connection here. The original TBC-790 which was paired with the 7900 is an analog design and Ampex used some of the same modules as in the AVR-1.  However, we now use TBC-7's which work much better!
>>  
>> <vpr7900sml.jpg>
>>  
>> Don Norwood
>> Digitrak Communications, Inc.
>> www.digitrakcom.com
>>  
>> ----- Original Message -----
>> From: David Crosthwait
>> Yes Don it's your 7900.
>> 
>> Best Regards,
>> 
>> David Crosthwait
>> ______________________________________________
>> Please trim posts to relevant info when replying.
>> 
>> Change subject to reflect thread direction. Thanks.
>> _______________________________________________
>> 
>> Send QuadList list posts to QuadList at quadvideotapegroup.com
>> Your subscribe, unsubscribe and digest options are here:
>> http://mail.quadvideotapegroup.com/mailman/listinfo/quadlist_quadvideotapegroup.com
> 
> ______________________________________________
> Please trim posts to relevant info when replying.
> 
> Change subject to reflect thread direction. Thanks.
> _______________________________________________
> 
> Send QuadList list posts to QuadList at quadvideotapegroup.com
> Your subscribe, unsubscribe and digest options are here:
> http://mail.quadvideotapegroup.com/mailman/listinfo/quadlist_quadvideotapegroup.com
> ______________________________________________
> Please trim posts to relevant info when replying.
> 
> Change subject to reflect thread direction. Thanks.
> _______________________________________________
> 
> Send QuadList list posts to QuadList at quadvideotapegroup.com
> Your subscribe, unsubscribe and digest options are here:
> http://mail.quadvideotapegroup.com/mailman/listinfo/quadlist_quadvideotapegroup.com
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://quadvideotapegroup.com/pipermail/quadlist_quadvideotapegroup.com/attachments/20130419/d1b3bbf4/attachment-0005.html>