[QuadList] Capstan questions

[Bill Carpenter]

Back in the days before I knew anything about Quad (1968) the VR-7800 had the only useable Assemble mode. 

The practice of recording black and using only insert edits, was based on the fact that all of the Quads switched from control track playback to a reference oscillator at the point of the assemble edit. The VR-3000 always made good assemble, backspace edits.
The VR-7800 (pre-A, 1" helical scan) had a multi-tooth capstan tach (16) and a circuit to select the closest tach tooth to control track and use that as the reference for the record portion of an assemble edit, thus eliminating the assemble edit problem. I think this was Barry Guislinger's great idea!
When I explained this to good quad engineers, they were both pleased and suprised!

 
Bye for now, love to all, Bill & Gewyn & Ginger (whoof...whoof)


________________________________
 From: Don Norwood via QuadList <quadlist at quadvideotapegroup.com>
To: Quad List <quadlist at quadvideotapegroup.com> 
Sent: Wednesday, December 31, 1969 4:00 PM
Subject: Re: [QuadList] Capstan questions
 




In reply to the original question that Chris asked, I think I have a drawing 
that shows the tolerance for the Ampex VR series capstan.  I'll look for it. 
RCA used a smaller diameter capstan, so tolerances might be different in 
their case.

I think everybody understands that the goal in record mode is to move the 
tape at a constant and precise rate.  However, that doesn't happen in real 
life with the VR series as evidenced by the experiment that Chris did.  I've 
seen the same thing.  I'm not sure about the capstan tolerance issue, but I 
do know that tape slippage can affect the speed.  This can be caused by 
incorrect tape tensions, bad pinch rollers, slick capstans, or some 
combination of all of the above.  Further, the tape itself can slip 
differently depending on the backing.

Also, in the VR decks, remember that the capstan is not directly driven.  So 
the complete system includes the motor pulley, the mylar belt and the 
capstan pulley.  Remember that you have to properly set the tension on the 
belt.

More precise control of record speed can be achieved by using a high 
resolution tach that measures the tape motion, not the capstan speed.  That 
technology wasn't practical in early quad machines, and as others have 
pointed out, within practical limits, the error is corrected in playback 
anyway.

Don Norwood
Digitrak Communications, Inc.
www.digitrakcom.com 





______________________________________________
Please trim posts to relevant info when replying.

Change subject to reflect thread direction. Thanks.
_______________________________________________

Send QuadList list posts to QuadList at quadvideotapegroup.com
Your subscribe, unsubscribe and digest options are here:
http://mail.quadvideotapegroup.com/mailman/listinfo/quadlist_quadvideotapegroup.com
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://quadvideotapegroup.com/pipermail/quadlist_quadvideotapegroup.com/attachments/20140923/9242baef/attachment-0005.html>
-------------- next part --------------
An embedded message was scrubbed...
From: "Don Norwood" <quadlist at digitrakcom.com>
Subject: Re: [QuadList] Capstan questions
Date: Tue, 23 Sep 2014 13:24:40 -0400
Size: 5505
URL: <http://quadvideotapegroup.com/pipermail/quadlist_quadvideotapegroup.com/attachments/20140923/9242baef/attachment-0003.mht>