[QuadList] Phoenix Quad Videotape Group dinner

[COURYHOUSE at aol.com]

good  info....
 
what about  winding on my TR 5?
 
In a message dated 7/18/2012 6:12:35 A.M. US Mountain Standard Time,  
DennyD1 at verizon.net writes:


On Jul 17, 2012, at 11:58 PM, Ted  Langdell wrote:

> The tape pack is loose as there had been no  hold-down tape on the  
end.
> Handling recommendations given  the loose pack and debris?

I  suggest:

Use a household vacuum cleaner's soft brush on  the reel, especially  
the openings that reveal the tape edges, before  loading on a VTR to  
thoroughly remove loose debris.  If you  can, vacuum the exposed outer  
winding of tape as well.
Whatever you do, DO NOT wind it on an AVR-1 or AVR-3.  The loose  pack  
will confuse the vacuum tensioners in the AVR-1 or the  mechanical  
tensioners in the AVR-3, which could result in tape  damage.
Wind the tape SLOWLY on a good ol' VR-2000 or  VR-1200.  An AVR-2  
would probably be OK too.  After  completely winding the tape in one  
direction, remove the tape from  the original reel and clean the empty  
reel thoroughly with the  vacuum cleaner.  Wipe the reel with a  
slightly damp cloth both  inside and out (NOT paper towel; that would  
leave paper debris), let  dry, then wind the tape back onto the reel  
again.

Dennis Degan, Video  Editor-Consultant-Knowledge Bank
NBC Today Show, New  York





Please trim posts to relevant info when  replying.

Change subject to reflect thread direction.  Thanks.
_______________________________________________



-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://quadvideotapegroup.com/pipermail/quadlist_quadvideotapegroup.com/attachments/20120718/c3322f58/attachment-0005.html>