[QuadList] Anamoaly on Rockethub Page

[chill315 at aol.com]

You have answered a few questions.  The only thing is that one has to assume that it is the same head in all the pictures.  

I would agree that it is a 15 head because of the probability of any other is so small.  But if the firing squad was cleaning the rifles and loading them as I was asked the question, I would not bet the life on it.

Chris Hill

On Apr 3, 2013, at 10:44 AM, "Don Norwood" <dwnorwood at embarqmail.com> wrote:

> 
> Hi Chris:
>  
> Not certain about the VR-1000 but I have seen Mk-III heads with the manual positioner installed although they could have been for the 1100.
>  
> The guide servo was not available for the VR-1100.  As you point out, the manual positioner was available for the Mk-X used on those machines, and in fact, the X was required for most of the 1100's beyond the early production units which used the Mk-III.  All later 1100's had an additional chassis with the individual channel adjustments and included a label on the deck plate stating that a Mk-X head was required.
>  
> The guide servo was an option on the VR-1200, although I've not seen one without it except in catalog pictures.  The 1200E does not include a control on the operator panel, so I assume it was not offered and certainly wasn't needed for recording.  I suppose a studio machine used only for recording would have no need for one either, so maybe some 1200's were sold in that configuration.
>  
> There is however, a definitive way to determine if the head shown in the pictures is a X or a XV.  Only the machine-mounted head in the next to last pic is a XV.
>  
> Don Norwood
> Digitrak Communications, Inc.
> www.digitrakcom.com 
> ----- Original Message -----
> From: Chill315 at aol.com
> The first guess would be that the head has a manual guide adjuster on it.  This was on the Mark 15 heads.  
>  
> But there were some machines that may have not used the auto guide assembly.  I say this as the guide was listed as an accessory in the set of books. 
>  
> So does anyone know if there was a machine that did not have the electronic guide assembly in the VR-1000, 1100, or 1200 series.  How about the E models that were the low boy so called portable units?  Or the 1100's?
>  
> Now Mark 10 heads could be used in earlier machines.  There was a trimmer module that replaced the nuvistor or transistor pre amp that allowed this.
>  
> Chris Hill
> 
> ______________________________________________
> Please trim posts to relevant info when replying.
> 
> Change subject to reflect thread direction. Thanks.
> _______________________________________________
> 
> Send QuadList list posts to QuadList at quadvideotapegroup.com
> Your subscribe, unsubscribe and digest options are here:
> http://mail.quadvideotapegroup.com/mailman/listinfo/quadlist_quadvideotapegroup.com
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://quadvideotapegroup.com/pipermail/quadlist_quadvideotapegroup.com/attachments/20130403/bfa1ec92/attachment-0004.html>