[QuadList] VR-1200 update

[Don Norwood]

Shai

The control for the guide servo, both activation and error signal, comes 
from Module 12 (Sync Proc) in the signal system.  I assume that the relay 
you are referring to is K2 on the guide servo chassis.  With the front panel 
guide mode switch set to Auto, the illumination level of the Auto switch cap 
should change between bright and dim as the K2 relay is changing.  You 
should verify the proper setup of  the Signal System (NOT Servo) module 12 
and repair if needed.  There is no warning light for the lock status of Bd 
12 other than the proper functioning of the guide servo Auto mode.

Don Norwood
Digitrak Communications, Inc.
www.digitrakcom.com