[QuadList] Bill's AVR-2 bridge switcher

[Don Norwood]

Park:

On a "non-Merlin" machine, Velocity error is the signal to monitor when setting guide height (assuming it has Velcomp installed!).  Does the Merlin machine have an equivalent monitor signal for velocity?

Don
  ----- Original Message ----- 
  From: C. Park Seward 


  To that point, on a 1200B, I like to set a scope to "AMTEC error" which helps set the tip penetration and guide height. The servo works well but I like to monitor it. A separate waveform and vectorscope is attached to the video out.


  Best,
  Park
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://quadvideotapegroup.com/pipermail/quadlist_quadvideotapegroup.com/attachments/20090915/6b2dcdfc/attachment-0004.html>